SNES TSOP burnt chip problems

  • I use a 29F033C with a DIP36-TSOP40 Adapter (III).
    When i put
    the game into the SNES, it worked for a couple of seconds and showed the Squaresoft logo, then it failed.
    It gave a burnt smell, and when i look at the 29F033C chip, i can see that pins 29 VSS, 30 VSS, 31 VCC are burnt.


    I have bridged R1 and R3 on the adapter board.


    Does anyone have a clue what i am doing wrong?


    PCB


    Pins 21-40

  • Hi,


    29 and 30 are VSS = GND: You could solder a bride and Connect a cable to the GND Point 18. Close the third jumper and try again.


    The pin 31 is vcc and should work. If the connect is broken, you should got only a black screen.


    Maybe, you have a broken solderpad. Please resolder all connections on the backside of the pcb.


    thanks


    red

  • Hi and thank you for your response!


    It seemed to work for a couple of seconds, but then it turned black and i smelled the burnt chip.
    I will try that to connect VSS to GND pin later and see if that works, and also close R2